Author Topic: Aluminum fin pipe  (Read 3980 times)

Offline SKieling

  • Newbie
  • *
  • Posts: 4
    • View Profile
Aluminum fin pipe
« on: February 18, 2013, 04:12:45 PM »
I need to replace the fin pipe in one of my kilns. I'm considering aluminum fin on an aluminum coated steel pipe. Its an American Wood Dryers design. Does anyone have experience with this type of heat coil. Thanks for your help.

Offline SenecaMike

  • Newbie
  • *
  • Posts: 8
    • View Profile
Re: Aluminum fin pipe
« Reply #1 on: February 19, 2013, 08:06:36 AM »
 They may work great, but I didn't go that route.  Aluminized steel fins are tougher in case of a board contacting them.  I also was concerned about the different heat expansion rates with aluminum and steel. 

Angus low

  • Guest
Re: Aluminum fin pipe
« Reply #2 on: April 10, 2013, 01:36:22 PM »
I do, they do bent easy and require mantenance if you want to keep them efficent. I also keep mine blown out because they are tightly spaced.

 


* Recent Posts

post Re: EMC Mistifyer
[General Discussion]
Dean
May 14, 2019, 04:50:35 AM
post Re: EMC Mistifyer
[General Discussion]
MichaelM
May 14, 2019, 04:20:43 AM
post EMC Mistifyer
[General Discussion]
Dean
May 13, 2019, 08:28:04 AM
post G2 Boiler Operator I
[Job Postings]
admin
May 09, 2019, 09:20:18 AM
post G3 Planer Set-up Swing Shift - Plummer, ID
[Job Postings]
admin
May 09, 2019, 09:10:17 AM
post Dry Side Superintendent--Dodson, LA
[Job Postings]
admin
May 08, 2019, 02:29:08 PM

Search


* Forum Experts

MichaelM MichaelM
Forum Expert
TimothyD TimothyD
Forum Expert
PhilM PhilM
Forum Expert
StavrosA StavrosA
Forum Expert

* Subscribe to Newsletter

\
SimplePortal 2.3.6 © 2008-2014, SimplePortal