Author Topic: Is my kiln schedule not long enough?  (Read 1278 times)

Offline admin

  • Administrator
  • Kiln Drying Tutor
  • *****
  • Posts: 100
  • Kiln drying enthusiast
    • View Profile
Is my kiln schedule not long enough?
« on: July 28, 2017, 09:54:16 AM »
When re-sawing 8Q cedar, high moisture is in the very center causing cupping of the boards. Is my kiln schedule not long enough? How can I correct this?

Question by Kevin S. from Carl Diebold Lumber in Troutdale, OR

Offline MichaelM

  • Forum Expert
  • Kiln Drying Enthusiest
  • *****
  • Posts: 95
    • View Profile
Re: Is my kiln schedule not long enough?
« Reply #1 on: July 28, 2017, 12:50:50 PM »
Kevin,

High MC in the center is not the root cause of the cupping. 

There is stress in kiln dried lumber.  The stress is relieved during a conditioning process during which the wood is exposed to an equilibrium moisture content about 4% greater than the target moisture content.  This is easily accomplished when the target MC is 10% or less.

It is difficult to get the EMC in the kiln high enough if the wood is greater than 10% moisture content.  So the cupping in the wet wood is likely due to stress.

I would also guess that the cupping has some time delay - it might take 6 to 12 hours for it to fully cup.  This is partly due to the MC change as you suggest, but it is also due to the viscoelastic nature of the wood.  There would be a time delay even if there was a uniform MC throughout the piece.

Hope this helps.
Mike M.

 


* Recent Posts

post Re: EMC Mistifyer
[General Discussion]
Dean
May 14, 2019, 04:50:35 AM
post Re: EMC Mistifyer
[General Discussion]
MichaelM
May 14, 2019, 04:20:43 AM
post EMC Mistifyer
[General Discussion]
Dean
May 13, 2019, 08:28:04 AM
post G2 Boiler Operator I
[Job Postings]
admin
May 09, 2019, 09:20:18 AM
post G3 Planer Set-up Swing Shift - Plummer, ID
[Job Postings]
admin
May 09, 2019, 09:10:17 AM
post Dry Side Superintendent--Dodson, LA
[Job Postings]
admin
May 08, 2019, 02:29:08 PM

Search


* Forum Experts

MichaelM MichaelM
Forum Expert
TimothyD TimothyD
Forum Expert
PhilM PhilM
Forum Expert
StavrosA StavrosA
Forum Expert

* Subscribe to Newsletter

\
SimplePortal 2.3.6 © 2008-2014, SimplePortal