Wood Drying Topics

No New Posts

Dry Kiln Maintenance

Are Dry Kilns high maintenance or low maintenance? Can good or bad kiln maintenance affect the quality of the lumber you dry?

50 Posts
11 Topics

Last post by GeorgeCulp
in Coils....Horizontal or V...
on February 24, 2015, 02:09:57 PM

No New Posts

Stacking/Sorting Wood

Stacking lumber for drying is a critical part of producing quality lumber. Sorting lumber before drying simplifies stacking and also aids in placing material of similar drying characteristics in the same kiln charge. The extent of sorting depends on practical considerations--some sorts are almost unavoidable, whereas others are sometimes omitted. Lumber can be sorted by species, moisture content, heartwood and sapwood, wetwood, grain, grade, thickness, and length.

34 Posts
12 Topics

Last post by rfosters
in Re: Stacking Frozen Lumb...
on January 21, 2015, 10:52:59 AM

No New Posts

Impact on Planing

Drying impacts the planing process. Wood that is too wet or too dry may have a chipped or fuzzy surface. Over-dry lumber may result in skip and slow the planer feed speed. Moisture content measurement at the planer can be used to improve the drying process. Feedback from the planer to the kilns is essential to improve or maintain quality drying.

15 Posts
5 Topics

Last post by cork46
in Re: drying 2" Douglas Fi...
on May 08, 2014, 11:07:38 AM

No New Posts

Dry Kiln Control

Lumber dry kiln control systems control the environmental conditions of heat, relative humidity, and air circulation necessary for the proper drying of hardwood and softwood. These control systems are usually personal computer (PC) or programmable logic controller (PLC) based. On some older systems, cam follower control is used. Dry kilns typically dry lumber to between 3 and 19 percent moisture content.

44 Posts
12 Topics

Last post by GeorgeCulp
in Re: Kiln heating
on February 24, 2015, 02:04:46 PM

No New Posts

Moisture Variability

Variability in wood properties causes boards within a stack of lumber to dry at different rates and reach different moisture content levels after drying is completed. The consequence is that the boards will have properties that differ from ones that were intended to be achieved by the drying process.

58 Posts
21 Topics

Last post by StavrosA
in Using Near-Infrared Dete...
on September 16, 2014, 08:54:42 AM

No New Posts

Drying Defects

Wood drying may be described as the art of ensuring that gross dimensional changes through shrinkage are confined to the drying process. Ideally, wood is dried to that equilibrium moisture content as will later (in service) be attained by the wood. Thus, further dimensional change will be kept to a minimum.

13 Posts
5 Topics

Last post by HencoV
in Re: End of Log Sealing
on April 13, 2014, 10:49:02 PM

No New Posts

Mold & Stain Issues

Some stains are chemical and some stains are biological. It is important for the operator to distinguish these. Stains sometimes appear, and then go away on their own. Processing time from when the tree is felled to when the wood is dried is a major factor in controlling stain. Storage conditions for the logs and lumber are important. The kiln temperature, humidity, and airflow can make the problem worse. Insect discussions are welcome here too.

26 Posts
9 Topics

Last post by admin
in Tips for Avoiding Mold, ...
on January 15, 2015, 08:52:50 AM

No New Posts

General Discussion

Feel free to talk about anything and everything related to kiln drying for the wood industry in this board.

152 Posts
48 Topics

Last post by MichaelM
in Re: Other Benefits to Co...
on February 24, 2015, 01:13:55 PM

No New Posts

Industry Articles

Feel free to post industry articles related to kilndryn for the wood industry.

8 Posts
6 Topics

Last post by M Gallahar
in Investigation of Histori...
on November 24, 2014, 11:58:23 AM

No New Posts

Training / Events

Find information here on upcoming Trade Shows, Training or Association Meetings

8 Posts
8 Topics

Last post by UBCcawp
in UBC Kiln Drying Workshop...
on February 17, 2015, 04:18:51 PM

No New Posts

Job Postings

A Place for associations and members to post Wood Drying related jobs

11 Posts
11 Topics

Last post by admin
in Dry End Supervisor - Moy...
on February 24, 2015, 07:55:06 AM

No New Posts

News

Look here for industry news!

3 Posts
3 Topics

Last post by admin
in Shrinking timber supply ...
on February 24, 2015, 10:28:49 AM

  • No New Posts
  • Redirect Board

Kiln Drying Forum - Info Center

Upcoming Calendar Upcoming Calendar

Upcoming Events: 2015 SLMA Spring Meeting & Expo, Canadian Woodlands Forum Spring Meeting, Reliable Plant Conference & Exhibition, 2015 Forest Products Machinery and Equipment Expo

Forum Stats Forum Stats

422 Posts in 151 Topics by 254 Members. Latest Member: Josh Goin
Latest Post: "Coils....Horizontal or V..." ( February 24, 2015, 02:09:57 PM )
View the most recent posts on the forum.
[More Stats]

Users Online Users Online

9 Guests, 1 User

Users active in past 15 minutes:
normzcadiz

Most Online Today: 10. Most Online Ever: 47 (July 17, 2011, 08:36:25 AM)


Users found this pages searching for:

google kilndrying 60444564 cwc kilnderying bing kilndrying 5118 google kilndrying 81456516 exy google kilndrying 51156542 agc com google kilndrying 42080656 ewu google kilndrying 55123115 bge google kilndrying 49478099 awm google kilndrying 53371865 cge google kilndrying 46226182 cge
schedule google kilndrying 57155469 bgq kilndrying post kilndrying get google 15424 post kilndrying get kilndryin search yahoo kilndrying bsfh9eq6cg1c- google kilndrying 57752919 bgq google kilndrying 57967247 zgu google kilndrying 41248874 b2u google kilndrying 43148975 b2i google kilndrying 58187178 bmk

Forum experts

MichaelM lmod MichaelM
Michael Milota Ph.D.
Professor
Oregon State University
READ BIO
PhilM lmod PhilM
Phil Mitchell Ph.D.
Forum Expert
North Carolina State University
READ BIO
StavrosA lmod StavrosA
Stavros Avramidis Ph.D.
Professor
University of British Columbia
READ BIO
TimothyD lmod TimothyD
Timothy Duncan MBA
Engineering Manager
Wagner Meters
READ BIO

* Events


* Job Opportunities

topic Dry End Supervisor - Moyie Springs, ID
[Job Postings]
admin
February 24, 2015, 07:55:06 AM
topic Dry End Supperintendent - Port Angeles, WA
[Job Postings]
admin
February 11, 2015, 03:52:37 PM
topic Kiln Supervisor - Tacoma, WA
[Job Postings]
admin
February 11, 2015, 03:46:34 PM