This forum is now closed and archived but the many helpful kiln-related topics are still available to view.
Please feel free to read through the archive or visit www.wagnermeters.com
for more detail about our wide array of moisture measurement solutions.

Author Topic: Water Supply Issues  (Read 5013 times)

Offline AliciaS

  • Administrator
  • Newbie
  • *****
  • Posts: 16
    • View Profile
Water Supply Issues
« on: September 29, 2015, 12:53:16 PM »
Question received by mill personnel:
We are currently using a Dry bulb/Wet bulb setup in in our kilns but are constantly having trouble with water supply issues. Is there a reliable electronic RH sensor that can take the stress of being in a dry kiln environment?

« Last Edit: September 29, 2015, 12:59:57 PM by admin »

Offline TimothyD

  • Forum Expert
  • Newbie
  • *****
  • Posts: 33
    • View Profile
Re: Water Supply Issues
« Reply #1 on: September 30, 2015, 08:47:37 AM »
That is an interesting concept.  I have a couple follow up questions:
Would an RH Sensor, providing %RH and temperature be sufficient to replace a Dry Bulb/Wet Bulb setup?
What would be the maximum temperature that the RH Sensor might need to operate in?
What RH levels might the RH sensor be exposed to during a typical charge? 

Knowing this data, would allow me to investigate a solution.

Tim

Offline MichaelM

  • Forum Expert
  • Kiln Drying Enthusiest
  • *****
  • Posts: 98
    • View Profile
Re: Water Supply Issues
« Reply #2 on: September 30, 2015, 10:35:55 AM »
There is a discussion of relative humidity measurement at https://en.wikipedia.org/wiki/Hygrometer

The wet-bulb is commonly used in kilns because of the chemicals in the atmosphere and the temperature.

Other sensors rely on resistance or capacitance and the materials generally don't work at high temperature.  Not in the wiki reference are ir sensors - water vapor attenuates the ir waves.  These are probably the most accurate, but the electronics are temperature sensitive.  Expensive too.

The resistance device that has been used in kilns is a cellulose wafer place between two electrodes.

The humble dry/wet bulb is robust and inexpensive.  The sensor (the sock) is easily changed when contaminated.

As to the original question - I would be curious what the water supply issue is.  This would seem easier to solve that figuring out a new sensor. 


Offline TimothyD

  • Forum Expert
  • Newbie
  • *****
  • Posts: 33
    • View Profile
Re: Water Supply Issues
« Reply #3 on: September 30, 2015, 10:45:27 AM »
Great points, Mike!
We use an RH sensor in one of our other products, but it's normal operating range is only up to 140 F in the higher humidity range, and this is a rather high end sensor.

 


Search


* Forum Experts

MichaelM MichaelM
Forum Expert
TimothyD TimothyD
Forum Expert
PhilM PhilM
Forum Expert
StavrosA StavrosA
Forum Expert

* Subscribe to Newsletter

* Upcoming Events

Sorry! There are no calendar events available at the moment.
\
SimplePortal 2.3.6 © 2008-2014, SimplePortal